1
|
To measure DC voltage and current, AC voltage and current with multi-meter
|
2
|
To observe waveforms on oscilloscope, measure basic parameters amplitude and frequency of sine wave and square wave.
|
3
|
Obtain VI characteristics of semiconductor rectifier diode, LED, Photo-diode
|
4
|
To observe waveform at the output of half wave rectifier with and without filter capacitor. To measure DC voltage, DC current, ripple factor with and without filter capacitor
|
5
|
To observe waveform at the output of full wave rectifier with and without filter capacitor. To measure DC voltage, DC current, ripple factor with and without filter capacitor
|
6
|
To observe waveform at the output of bridge rectifier with and without filter capacitor. To measure DC voltage, DC current, ripple factor with and without filter capacitor
|
7
|
To construct clamper circuits on breadboard and To observe waveforms at the output of clamper circuits
|
8
|
To construct clipper circuits on breadboard and To observe waveforms at the output of clipper circuits
|
9
|
Construct AND gate & OR gate with help of diode and verify truth table
|
10
|
To obtain common emitter characteristics of NPN transistor
|
11
|
To obtain common base characteristics of NPN transistor
|
12
|
To obtain common collector characteristics of NPN transistor
|
13
|
To design common emitter amplifier and construct circuit on breadboard. Measure gain at different frequencies and plot frequency response
|
14
|
To understand working of transistor as a switch. To draw DC load line for given circuit.
|
15
|
To observe input-output waveforms of common collector (CC) amplifier. To measure gain of amplifier at different frequencies and plot frequency response
|
16
|
To obtain characteristics of field effect transistor (FET)
|
17
|
To measure gain of FET common source (CS) amplifier
|
18
|
Verify truth table of basic digital logic gates OR, AND, NOT, NAND, NOR, EX-OR, EX-NOR
|
19
|
To test individual circuit prepared by the student (Get circuit from the faculty, build it, draw circuit diagram and test it in the laboratory. Write test results in this practical)
|